PFFlag: if set, means that the Permanent failure flag has been set with our current settings this bit should never be set.AFEFail: if set, means that communication between the microcontrollers of the chipset have failed.VDQ, Valid Discharge Qualified: the current or next discharge cycle is valid for an update of the Full Charge Capacity.SEALED: if set, means that the parameters of the battery are sealed and cannot be accessed for read/write.This voltage level is compensated and calculated automatically based on the discharge conditions, such as instant current, cell temperature and cells internal impedance. EDV2: if set, means that the internal cell stack voltage has reached the EDV2 voltage threshold that corresponds to the "Battery Low" remaining cpacity (programmed at 8%).PRES: with our current settings this bit should always be set.Each bit is set (ON) when higlighted, OFF when grayed. Gives some information about Pack status bits. ERR, Error Codes: show some possible internal errors, if different than 0x00.Reaching this level makes the LEDs flash when the LED button is pressed. FD, Fully Discharged: if set, means that the Relative State of Charge has reached the "Battery Low" level, programmed at 8%.FC, Fully Charged: if set, means that the battery has detected a primary charge termination or an Overcharge condition.DSG, Discharging: if set, means that the battery is not being charged.INIT, Initialised: if set, means that the microcontroller is correctly initialised.if set, means that the estimated remaining time at the present discharge rate is less than the set threshold (10 minutes)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |